1. New block or flagstone paving should be swept clean, ensuring there is sufficient well-compacted sand in the joints. Existing paving should be pressure washed to remove all surface debris. If the area is contaminated with weeds & moss then it should be treated with PICS Fungicidal Wash.

2. Shake the drum of PICSEAL to ensure there is no settlement in transit.

3. Decant the PICSEAL into a sprayer unit or clean watering can with a rose attachment.

4. Apply the PICSEAL at a rate of 3m2/litre on block paving or flagstones. A two-coat spray application is required to fully cover the jointing sand.

5. Remove any excess sealer from the surface using a flexible squeegee. Any excess will be pushed into the jointing sand.

6. PICSEAL will be tack free within 3 hours at 20°C.

7. PICSEAL will have cured sufficiently for foot traffic after 6 hours and cars after 48 hours.

FURTHER TECHNICAL ADVICE
Should further specific technical advice be required contact the Technical Department on :-

Phone UK (01635) 202224
FAX (01635) 202230

Phone International +44(0) 1635 202224
Fax International +44(0) 1635 202230

E-mail info@picsuk.com
Web Site www.picsuk.com