PRODUCT DESCRIPTION
PICSPAVE (RA) is a pre-mixed, coloured blend of sub-micronic powders.

PURPOSE
To allow easy and free release of PICSPAVE Textured Imprinting Mats from the wet surface of concrete after application and finishing of PICSPAVE CSH and to create secondary pigmentation of the low points of the textured surface by imparting a contrasting colour.

SPECIAL PROPERTIES

• Allows deep and complex imprints and easy imprinting mat removal without surface tearing.
• Will not cake or become brittle on wet surfaces
• Excellent surface adhesion - not removed by wind once applied.
• 100% Hydrophobic to create a total moisture barrier.
• Available in 12 standard colours that are inter-compatible and can be blended with confidence to create special colours.
• Free flowing yet cohesive - does not segregate upon application.
• Ultra Violet (UVA) stable pigments conform to BS1014 guarantee colours will not fade as a result of direct sunshine.

PACKAGING
10kg Snap Lock Plastic Pail.

APPROXIMATE COVERAGE
6m2 to 7m2 per kg.

HEALTH AND SAFETY
Non-flammable and non-toxic. Sub-micronic powder, wearing of approved respirator is recommended. Store in a cool, dry area and avoid exposure to heat or flame. Refer to the Health & Safety Data Sheet for further details.

APPLICATION INSTRUCTIONS
After the CSH has been applied to the concrete, floated, trowelled and tested for firmness, RA should be applied after being thoroughly hand mixed in its container. RA should be gently cast onto the concrete surface, do not cast over long distances as it will become airborne. Do not over apply - only a very thin layer is needed, sufficient has been applied when the CSH colour is masked by the colour of the RA. When the area to be printed has been covered with RA, the first imprinting mat can be placed.

SPECIFICATION CLAUSE
"Immediately prior to imprinting, the concrete shall be dusted with PICSPAVE RA which shall combine imprinting mat release without surface tearing, anti-caking and surface adhesion capabilities and impart a secondary colour in the low points of the textured surface.

All the work shall be carried out in accordance with the manufacturers current technical data sheet, specification and instructions for use by trained contractors duly certificated and authorised by Pattern Imprinted Concrete Supplies Ltd".

TECHNICAL SERVICES
For further information, call our Technical Dept on:-

Phone UK (01635) 202224
FAX (01635) 202230

Phone International +44(0) 1635 202224
Fax International +44(0) 1635 202230

E-mail info@picsuk.com
Web Site www.picsuk.com

Close Window